Stainless steel brackets

Component generally used in combination with the 0° outlet element, both single-wall and double-wall. It can be used to support the duct in sub-horizontal sections.

Adjustable wall bracket

Component used to anchor the chimney/flue system to the wall. Its key feature is the ability to adjust the distance from the wall.

Adjustable wall collar (every 2 m)

Component used to anchor the chimney, flue system, and flue pipe to the wall. Its key feature is the ability to adjust the distance from the wall.

Spacer collar

Component required to center the duct within the shaft/technical opening.

Wall-mounted chimney support

Component required to support the chimney/flue system where no support from existing structures is available. For self-supporting values, refer to the “Compression Resistance Table” data sheet.

Wind anchoring ring

Component to be used to brace the chimney cap when no other supports are available.

Stainless steel female socket cap

Component used as a closing cap. The female socket allows closure of all male connections. Also available in a male socket version, art. 45130.

Compensation socket plug

Component that allows air to enter the chimney or collective flue. In column C, values are expressed in cm² of free cross-sectional area.

Flashing cover (to be paired with flashings)

Component used as a tightening flashing around the pipe. When combined with flashing code 4510… and code 4511…, it prevents water infiltration.

Sloped stainless steel flashing (5°–30°)

Component designed for use on pitched roofs with a slope from 5° to 30°. When combined with flashing cover code 4512…, it prevents water infiltration.

Flat stainless steel flashing (0°)

Component designed for use on flat roofs. When combined with flashing cover code 4512…, it prevents water infiltration.

Condensate collecting end plate

Closing component that can be used as the terminal part of the pipe system, with the specific feature of sliding inside the pipe.

Sealed round cap

Component used as a tight-sealing T200 P1 end cap for a male connection. The sealing gasket complies with EN 14241-1. In version art. 4592, the sealing gasket is replaced by a steel spring, allowing a T600 N1 designation.

Single-wall flat plate for slab finishing

Component used to restore passage openings in floors or walls. It must not be used as protection for any combustible materials. It can also be manufactured with a slope, resulting in dimensions A and D varying accordingly.